PROTECT EP-resin

article number 040020

PROTECT resin system

Non-positive filling of cracks and joints. Injection into injection hoses. Suitable for dry and moist substrate

Processing time approx. 45 min. at 20°C

1 l combination can

800 ml component A

200 ml component B

component A (800 ml)

UN-Nr.3082, hazardous goods class 9,
packing group III

component B (200 ml)
UN-Nr.2735, hazardous goods class 8,
packing group III

available in large quantities

Add to notice list

The most important information at a glance

technical data

article number:

040020

GTIN:

4251689515026

customs tariff number:

39073000

packing unit:

Liter

sales quantity unit:

1 Liter

weight per:

Liter = 1.3 kg

material:

epoxy resin

colour:

transparent

consistency:

fluid

viscosity 310 mPa.s (low viscosity)

density:

approx. 1,08 g/cm³

mixing ratio:

4 : 1 (component A : component B)

surface tension:

approx. 24,04 mN/m

compression strength :

approx. 60 N/mm²

tensile strength:

approx. 45,7 N/mm²

elongation:

approx. 6,1 %

e-Modulus:

approx. 2600 N/mm²

application time:

approx. 25 minutes, relating to 100 g

application temperature:

+ 8 °C up to + 35 °C

substrate- and materialtemperature

Packing:

1 l combination can

800 ml component A

200 ml component B

Carton:

6 cans

storage:

Store in undamaged and unopened original packaging in a dry place out of direct sunlight.
Stockable for one year at temperatures between + 5 °C to + 25 °C.

disposal:

Disposal must be in accordance with the pertinent national and local regulations. Hardened materials
may be disposed of with regular
household/commercial waste. Cartridges containing residual paste must be treated as colour waste.

data sheet download

Installation tutorial

Application:
PROTECT EP resin is an epoxy-based duromer resin with a low-viscosity. The resin has a high penetration activity.
The PROTECT EP resin has a short setting time on dry as well as on moist substrates and hardens even under dynamic stress.
After hardening, the PROTECT EP resin has a very high compressive and tensile strength.

Preparation:
Before injection, the structure has to be inspected according to technical standards.

Mixing:
PROTECT EP resin consists of two components, component A and component B. They have to be mixed according to the recommendad ratio using slowly rotating stirrers until the mixture is homogeneous.
Before processing, the mixed reactive resin has to be repotted into a clean and empty container or a container in which only mixed resin of the same quality was stored.
Repotting is fulfilled when the resin is poured into the reservoir of an injection pump and remixed thoroughly.
The application time depends on the quantity of the mixed material and the ambient temperature.

Injection:
Injection is done with an injection pump.
The selection of the right injection packer depends primarily on the required injection pressure.
Work with PROTECT EP resin must be stopped if the temperature of the structure drops below +8 °C.

Cleaning:
Within the application time all tools can be cleaned with PROTECT Clean.
Partially or completely cured material can only be removed mechanically.

Download installation tutorial