STOPPER Screw Typ 3 - 17 up to 19,5 mm

article number 046230

Stopper Screw

Plastic-Screwed inner seals

Add to notice list

The most important information at a glance

start Animation

technical data

article number:

046230

GTIN:

4251689538025

customs tariff number:

39259080

packing unit:

Bucket

sales quantity unit:

100 Stk

weight per:

Bucket = 2.5 kg

material:

screw / nut / pressure plate: stainless steel V2A
rubber seal: thermoplastic elastomer
claw: polyoxymethylene

colour:

screw: silvery
nut: silvery
pressure plate: silvery
rubber seal: black
claw: green

inner diameter of tie point :

17 to 19,5 mm

Ø pressure plate :

15,5 mm

overall length:

65 mm

storage:

Store in undamaged and unopened original packaging in a dry place out of direct sunlight

disposal:

Can be disposed of at municipal waste landfill sites or waste incineration plants, taking into account the local waste disposal regulations

data sheet download

Installation tutorial

Scope of delivery

The STOPPER SCREW type in is delivered ready for installation in a plastic bucket (100 pcs.). Each bucket contains 2 bits, which are attached to the inside of the lid.

Installation tools
For installation you need:

- Cleaning brush
- Cordless screwdriver with a power of ≥ 14.7 V
- Bit holder for cordless screwdriver
- Hammer for driving in and positioning

Preparation of tie point

Clean the inside of the tie point. Remove loose particles and dust before installation of STOPPER SCREW type in.

1. Insertion

Insert the STOPPER SCREW type in into the clean tie point to be sealed. To do this, position the claw of STOPPER SCREW type in in such a way that all 4 claw ends are inside the clearance of the tie point. With a hammer blow onto the pressure plate the claw of STOPPER SCREW type in slips into the tie point and centres itself. The STOPPER SCREW type in can now be positioned.

2. Positioning

Push or drive the STOPPER SCREW type in into the desired position in the tie point. For a flush seal, after tightening, the untensioned STOPPER must protrude approx. 7 mm above the tie point.

Alternatively with STOPPER SCREW positioning aid

The use of the STOPPER SCREW positioning aid makes positioning much easier due to the recess on the front side.

3. Tightening

Tighten the screw of STOPPER SCREW type in with a cordless screwdriver. Use speed class 1. It cannot be overtightened due to the integrated tightening limit. A cordless screwdriver with a power class of 14.7 V will reach a torque of 4 Nm at maximum load. The pressure test was performed with this tightening torque.