STOPPER SCREW | Type in -> STOPPER SCREW 20 in | 19.5-22 mm

STOPPER SCREW 20 in | 19.5-22 mm

Type 4-in; tie point inner dia. 19.5-22 mm

Article number 046240

STOPPER SCREW | Type in

Produktbeschreibung

Screwed sealing of formwork tie points

Maximum safety with excellent appearance
Also suitable for conical clamping points
Tested for: pressurized water, sound, radon, and fire protection

Get a quote now Add to notice list

The most important information at a glance

start Animation

Price list

Technical data

Article number:

046240

article group:

611 - Stopper Screw + Zubehör

GTIN:

4251689538049

customs tariff number:

39259080

packing unit:

Bucket

sales quantity unit:

100 Stk

material:

screw / nut / pressure plate: stainless steel V2A
rubber seal: thermoplastic elastomer
claw: polyoxymethylene

colour:

screw: silvery
nut: silvery
pressure plate: silvery
rubber seal: black
claw: green

inner diameter of tie point :

19,5 to 22 mm

overall length:

72 mm

Substances according to the SVHC list contained or proportional weight ≥0.1%:

conform to REACH Guideline:

Yes

waterpressuretightness:

up to 4 bar

storage:

Store in undamaged and unopened original packaging in a dry place out of direct sunlight

disposal:

Can be disposed of at municipal waste landfill sites or waste incineration plants, taking into account the local waste disposal regulations

Data sheet

Installation instructions

Scope of delivery

The STOPPER SCREW type in is delivered ready for installation in a plastic bucket (100 pcs.). Each bucket contains 2 bits, which are attached to the inside of the lid. (STOPPER SCREW 31: 50 pcs. and 1 bit)

Installation tools
For installation you need:

- Cleaning brush
- Cordless screwdriver
- Hammer for driving in and positioning
- Torque control tool

Before installation, measure the internal diameter of the tie point at the intended installation position. This is particularly important for tapered tie points, as the diameter may vary depending on the installation depth. Select the appropriate STOPPER SCREW type in based on the measured diameter.

Preparation of tie point

Clean the inside of the tie point. Remove loose particles and dust before installation of STOPPER SCREW type in.

1. Insertion

Insert the STOPPER SCREW type in into the clean tie point to be sealed. To do this, position the claw of STOPPER SCREW type in in such a way that all 4 claw ends are inside the clearance of the tie point. With a hammer blow onto the pressure plate the claw of STOPPER SCREW type in slips into the tie point and centres itself.

2. Positioning

Push or drive the STOPPER SCREW type in into the desired position in the tie point. For a flush seal, after tightening, the untensioned STOPPER must protrude approx. 7 mm above the tie point.

3. Tightening

Tighten the screw of STOPPER SCREW type in with a cordless screwdriver. Use speed class 1.

Then tighten the screw of the STOPPER SCREW type in with the torque wrench to a torque of 4Nm (5Nm for conical anchor holes).
With our STOPPER SCREW torque set, this step can be done more easily.