STOPPER SCREW 17 covered

STOPPER SCREW 17 covered | 17-19.5 mm

Type 3-covered; tie point inner dia. 17-19.5 mm

article number 046330

STOPPER SCREW

Screwed sealing of formwork tie points - maximum safety with superb appearance

Get a quote now Add to notice list

The most important information at a glance

start Animation

Technical data

article number:

046330

article group:

611 - Stopper Screw + Zubehör

GTIN:

4251689538094

customs tariff number:

39259080

packing unit:

Bucket

sales quantity unit:

100 Stk

weight per:

Bucket = 4.5 kg

material:

screw / nut / pressure plate: stainless steel V2A
rubber seal: thermoplastic elastomer
claw: polyoxymethylene

colour:

screw: silvery
nut: silvery
pressure plate: silvery
rubber seal: black
claw: green

inner diameter of tie point :

17 to 19,5 mm

Ø pressure plate :

28 mm

overall length :

75 mm

Substances according to the SVHC list contained or proportional weight ≥0.1%:

conform to REACH Guideline:

Yes

waterpressuretightness:

5 bar in conical tie-holes

storage:

Store in undamaged and unopened original packaging in a dry place out of direct sunlight

disposal:

Can be disposed of at municipal waste landfill sites or waste incineration plants, taking into account the local waste disposal regulations

Data sheet

Installation tutorial

Scope of delivery

The STOPPER SCREW type covered is delivered ready for installation in a plastic bucket (100 pcs.). Each bucket contains 4 bits, which are attached to the inside of the lid. (Type 6: 50 pcs. and 2 bits)

Installation tools
For installation you need:

- Cleaning brush
- Cordless screwdriver
- Hammer for driving in and positioning
- Torque control tool

Preparation of tie point

Clean the inside of the tie point. Remove loose particles and dust before installation of STOPPER SCREW type covered .

1. Insertion

Insert the STOPPER SCREW type covered into the clean tie point to be sealed. To do this, position the claw of STOPPER SCREW type covered in such a way that all 4 claw ends are inside the clearance of the tie point. With a hammer blow onto the pressure plate the claw of STOPPER SCREW type covered slips into the tie point and centres itself.

2. Positioning

Push or hammer the STOPPER SCREW type covered completely into the tie point.

3. Tightening

Tighten the screw of STOPPER SCREW type covered with a cordless screwdriver. Use speed class 1.

Then tighten the screw of the STOPPER SCREW type covered with the torque wrench to a torque of 4Nm (5Nm for conical anchor holes).
With our STOPPER SCREW torque set, this step can be done more easily.