for joint sheet metal widths up to 250 mm
article number 070193
Joint sheet metal/ joint tape connector
The MASTER-Connect joint tape connector is the quick and easy way to ensure reliable pressure water-tight connection of two joint tapes in-situ.
No welding or vulcanisation required.
Add to notice listThe most important information at a glance
steel plates: St 37, bright
intermediate plates: specialty rubber
screws: galvanised
250 mm
100 mm
approx. 6 mm / 10 mm
Investigation report
UB 5.1/13-347
MFPA Leipzig
7 bar ( 70 m water column )
Oil and petrol
Liquid manure and slurry
Fermentation mash
Diluted acids
Alkalis
Radon and methane gas
1 piece per carton
2 pcs. steel plates, bright
2 pcs. specialty rubber plates,
6/8 pcs. NBR washers
3/4 pcs. M 10 screws, galvanised
3/4 pcs. M 10 nuts, galvanised
The product is delivered pre-assembled in a box
No
Yes
Remove the pre-assembled MASTER-Connect joint sheet metal from its box and erect vertically at its intended installation side.
Insert the sheet metal into the MASTER-Connect joint sheet metal from the left and right.
The sheet metal must be pushed between the two NBR plates until it is touching the bolts.
Use a torque wrench to tighten the bolts to 8 Nm torque.
Status: 23.03.2022
Similar products
You can find similar products here.
The MASTER-Connect joint tape connector is the quick and easy way to ensure reliable pressure water-tight connection of two joint ...
Contact us
We are happy to answer your questions