for joint tape widths up to 250 mm
article number 070610
Joint sheet metal/ joint tape connector
The MASTER-Connect joint tape connector is the quick and easy way to ensure reliable pressure water-tight connection of two joint tapes in-situ.
No welding or vulcanisation required.
Suitable for thermoplastic and elastomer joint tapes.
Add to notice listThe most important information at a glance
steel plates: St 37, bright
intermediate plates: specialty rubber
screws: galvanised
250 mm
100 mm
approx. 6 mm / 10 mm
Investigation report
UB 2.2/02-440
MFPA Leipzig
5 bar ( 50 m water column )
2 bar ( 20 m water column )
After deduction of an safety
coefficient of 2,5 ( Germany )
Liquid manure and slurry
Fermentation mash
Diluted acids
Diluted alkalis
1 piece per carton
2 pcs. steel plates, bright
2 pcs. specialty rubber plates,
6/8 pcs. NBR washers
3/4 pcs. M 10 screws, galvanised
3/4 pcs. M 10 nuts, galvanised
No
Yes
Remove the pre-assembled MASTER-Connect joint tape from its box.
Remove the horizontal waterstops (ribs) on both sides, at the front and back to the depth of insertion using a sharp utility knife.
It is essential to ensure as smooth an insertion surface as possible.
Insert the two ends of the joint tape into the MASTER-Connect joint tape connector until they are touching the bolts.
Use a torque wrench to tighten the bolts to 8 Nm torque
Status: 23.03.2022
Similar products
You can find similar products here.
The MASTER-Connect joint tape connector is the quick and easy way to ensure reliable pressure water-tight connection of two joint ...
Contact us
We are happy to answer your questions