engleză
STOPPER SCREW 31 covered | 31-34 mm
Numărul articolului 046360
Închidere cu șurub pentru punctele de prindere a cofrajelor
- Siguranță maximă cu un aspect remarcabil
- Potrivit și pentru puncte de prindere conice
- Testat pentru: Apă sub presiune, sunet, radon
Cele mai importante informații dintr-o singură privire
Start Animație
Șurub / piuliță / disc de presiune: Oțel inoxidabil V2A
Cauciuc de etanșare: elastomer termoplastic
Gheară: Polioximetilenă
31 până la 34 mm
38.5 mm
83 mm
Scope of delivery
The STOPPER SCREW type covered is delivered ready for installation in a plastic bucket (100 pcs.). Each bucket contains 4 bits, which are attached to the inside of the lid. (Type 6: 50 pcs. and 2 bits)
Installation tools
For installation you need:
- Cleaning brush
- Cordless screwdriver
- Hammer for driving in and positioning
- Torque control tool
Preparation of tie point
Clean the inside of the tie point. Remove loose particles and dust before installation of STOPPER SCREW type covered .
1. Insertion
Insert the STOPPER SCREW type covered into the clean tie point to be sealed. To do this, position the claw of STOPPER SCREW type covered in such a way that all 4 claw ends are inside the clearance of the tie point. With a hammer blow onto the pressure plate the claw of STOPPER SCREW type covered slips into the tie point and centres itself.
2. Positioning
Push or hammer the STOPPER SCREW type covered completely into the tie point.
3. Tightening
Tighten the screw of STOPPER SCREW type covered with a cordless screwdriver. Use speed class 1.
Then tighten the screw of the STOPPER SCREW type covered with the torque wrench to a torque of 4Nm (5Nm for conical anchor holes).
With our STOPPER SCREW torque set, this step can be done more easily.
STOPPER SCREW type covered mounted in tie point with cone.
Status: 14.12.2022
Accesorii
accesorii adecvate
Mastertec GmbH & Co. KG
Im Maintal 13
Gewerbegebiet Unterhaid
96173 Oberhaid
Obțineți o ofertă
Obțineți o ofertă pentru acest produs