fra natriumbentonitt
artikkelnummer 010012
MASTERSTOP "LONG TIME" bentonitt svelletape for sikker tetting av konstruksjonsfuger og gjennomføringer i betongkonstruksjoner mot inntrengning av vann. Vanninntrengning forhindres av svellingen og det svelletrykket som oppstår under svellingsprosessen.
MASTERSTOP LONG TIME bentonitt svelletape er en tetning som kan svelle i vann. Den består av et finmalt, svært svellbart leirmineral (natriumbentonitt) som bindemiddel i en matrise av ikke-vulkanisert gummi. For bedre værbestandighet er den belagt med en film som oppløses av seg selv i betongen. Legg til i varslingslistenDen viktigste informasjonen på et øyeblikk
Natriumbentonitt
Smooth
plast
Opp til 340 % i normalt vann (PH 7)
Opp til 150 % i
opp til 150 % i væsker som angriper betongen sterkt
.
opp til 290 % i alkaliske væsker
Nei
Ja
Nei
Ja
ETA - 16 / 0735
Testsertifikat for generelle bygningsmyndigheter (AbP), MFPA Leipzig
Nr.
Nr.: P-SAC 02 / 5.1 / 15-253
ca. 10 dager
utføres ca. 6-7 dager etter støping
Ja
Bruk klasse A for belastningsklasse 1 og 2 i samsvar med WU-retningslinjene
Since the MASTERSTOP "LONG TIME" is supplied with a protective sheating, the swelling tape can
only be fastened by using a special swelling tape grid.
The substrate must be clean, dry and free of loose parts.
Apply the MASTERSTOP "LONG TIME" in the middle of the joint to the concrete surface and fix it.
The later concrete cover must be at least 8cm.
The swelling tape must be bordered by reinforcement on both sides.
Minimum distance to the reinforcement: 5cm.
Place the swelling tape grid carefully over the swelling tape without damaging the protective sheating.
The grid must only be nailed on through the side wings.
Fasten with suitable nails either by hand or mechanically with a bolt-firing tool.
The distance between nails should not exceed 25 cm in the longitudinal direction of the swelling tape.
At the beginning of the tape and if tape sections are used, pull back the protective sheating approx. 5 cm, cut off the swelling tape and fold over the extra length of sheating to prevent contact with water.
In the corners, the swelling tape grid must be released in order to ensure a continuous firm fixation on the substrate.
In the case of butt joints in the straight line and the use of swelling tape grids, the joints of swelling tape and swelling tape grid should always be made in a staggered position.
Status: 23.03.2022
Tilbehør
egnet tilbehør
Svellende beltegitter for MASTERSTOP. "LONG TIME" 25/20, lengde 1 m ...
Lengde 42 mm med stor skive ...
Lengde 40 mm med skive ...
Lignende produkter
Du finner lignende produkter her.
Dette er en test...
Kontakt oss
Vi svarer gjerne på spørsmålene dine