z bentonitu sodowego
numer artykułu 010012
MASTERSTOP "LONG TIME" bentonitowa taśma pęczniejąca do bezpiecznego uszczelniania połączeń budowlanych i przejść w konstrukcjach betonowych przed wnikaniem wody. Penetracji wody zapobiega pęcznienie i ciśnienie pęcznienia powstające podczas procesu pęcznienia.
MASTERSTOP LONG TIME bentonitowa taśma pęczniejąca to uszczelnienie, które może pęcznieć w wodzie. Składa się z drobno zmielonego, wysoce pęczniejącego minerału ilastego (bentonitu sodowego), osadzonego jako spoiwo w matrycy z niewulkanizowanej gumy. Dla lepszej odporności na warunki atmosferyczne jest pokryta warstwą, która samoczynnie rozpuszcza się w betonie. Dodaj do listy powiadomieńNajważniejsze informacje w skrócie
Bentonit sodowy
Gładki
plastik
Do 340% w normalnej wodzie (PH 7)
do 150 % w cieczach silnie atakujących beton
do 290 % w cieczach alkalicznych
Nie
Ja
Nie
Ja
ETA - 16 / 0735
Ogólne świadectwo kontroli nadzoru budowlanego (AbP), MFPA Lipsk
Nr: P-SAC 02 / 5.1 / 15-253
około 10 dni
przeprowadza się około 6-7 dni po betonowaniu
Ja
Używaj klasy A dla klasy obciążenia 1 i 2 zgodnie z wytycznymi WU
Since the MASTERSTOP "LONG TIME" is supplied with a protective sheating, the swelling tape can
only be fastened by using a special swelling tape grid.
The substrate must be clean, dry and free of loose parts.
Apply the MASTERSTOP "LONG TIME" in the middle of the joint to the concrete surface and fix it.
The later concrete cover must be at least 8cm.
The swelling tape must be bordered by reinforcement on both sides.
Minimum distance to the reinforcement: 5cm.
Place the swelling tape grid carefully over the swelling tape without damaging the protective sheating.
The grid must only be nailed on through the side wings.
Fasten with suitable nails either by hand or mechanically with a bolt-firing tool.
The distance between nails should not exceed 25 cm in the longitudinal direction of the swelling tape.
At the beginning of the tape and if tape sections are used, pull back the protective sheating approx. 5 cm, cut off the swelling tape and fold over the extra length of sheating to prevent contact with water.
In the corners, the swelling tape grid must be released in order to ensure a continuous firm fixation on the substrate.
In the case of butt joints in the straight line and the use of swelling tape grids, the joints of swelling tape and swelling tape grid should always be made in a staggered position.
Status: 23.03.2022
Akcesoria
odpowiednie akcesoria
Kratka ochronna na pasek do MASTERSTOP "LONG TIME" 25/20, długość 1 m ...
Długość 42 mm z dużą tarczą ...
Długość 40 mm z tarczą ...
Podobne produkty
Podobne produkty można znaleźć tutaj.
To jest test...
Skontaktuj się z nami
Chętnie odpowiemy na Twoje pytania