avec technique de l'anneau en oignon - modèle divisé
numéro d'article 120171T
Aperçu des informations les plus importantes
Élément d'étanchéité : caoutchouc EPDM respectueux de l'environnement
.
Largeur du joint : 40 mm
Plaques de compression, vis, écrous : V2A
Plaques d'impression : argentées
M6
10 mm
5 Nm (at form stable media-pipes)
5 Nm at form stable media pipes
Without plug: 62 - 64 mm
1. Ring: 74 - 76 mm
2. Ring: 88 - 90 mm
3. Ring: 108 - 110 mm
Adjust the sealing insert of the MASTER-Ring Multi split version to the diameter of the media line. To do this, push the required rings backwards through the seal.
Remove the locking clip of the MASTER-Ring Multi split version
Open the gasket on the side of the puzzle pieces.
Place the MASTER-Ring Multi split version around the installed pipe.
Close the gasket and reinstall the locking clip and close it as well.
Push the seal into the annular gap.
Tighten the screws crosswise through one turn.
Tighten the screws to the specified max. torque. (Ø 100/150/200 = 5Nm; Ø250 = 10Nm).
Check the torque after 1-2 hours and retighten the screws if necessary.
Contactez nous
We are happy to answer your questions