engelsk
Fullt belagt på begge sider
artikkelnummer 070467
width 120 mm
packed in carton
incl. 2 fixing clips
water pressure test by MFPA Leipzig
groundwater neutral
Den viktigste informasjonen på et øyeblikk
St 37, galvanisert
.
Spesialbelegg: tekstilforsterket polymerplast
120 mm
Omtrent 0,6 mm
Omtrent 0,15 mm
.
Omtrent 0,9 mm
.
Generell prøvingsattest fra bygningsmyndighetene (AbP)
MFPA Leipzig
Ja
Bruk klasse A for belastningsklasse 1 og 2 i samsvar med WU-retningslinjene
Nei
Ja
Plater som allerede er montert i første betongseksjon, kan utsettes for fri UV-eksponering i maksimalt 4 uker inntil de er ferdig montert i betong. Hvis byggearbeidet avbrytes i en lengre periode, må platene beskyttes spesielt mot UV-stråler (mørk film osv. ...) for ikke å forringe deres brukbarhet.
Kartongeske (40 x 40 x 20 cm)
1 papirrull
1 rull papir
2 stk.
2 stk. trykklips
48 esker per pall
48 esker per pall
Remove the bottom half of the parted protective foil from the special coating.
Place the VB joint sheet metal in the centre of the rising wall on top of the upper reinforcement layer.
Push the mounting brackets with a maximum distance of 70 cm over the sheet metal and fix them to the upper reinforcement layer with binding wire.
The embedment depth in the concrete must be at least 3 cm and must not be more than half the height of the sheet metal.
The VB joint sheet metal must overlap by at least 6 cm in the area of the joint, in the straight sections and also in the corner area.
To do so, the upper protective foil must be turned back in the area subsequently to be joined.
Overlap the VB joint sheet metal by at least 6 cm and press the two ends firmly together.
The joint must be glued over its full height and entire surface to prevent subsequent water permeation.
There must be no contamination on the adhesive surfaces that could interfere with bonding.
Secure the joint with one of the fixing clips provided and fold the protective foil back onto the special coating.
Prepared joints in the straight sections as well as the corner area.
Once the foundation slab has been concreted, and before the wall formwork is closed or the double wall elements have been set up, the remaining protective foil must be removed.
The concreting of the wall base and corresponding preparations must be carried out in accordance with the established technical standards.
Status: 23.03.2022
Tilbehør
egnet tilbehør
Tetningsplatens skjøtebåndtilkobling er en enkel, rask og sikker måte å koble VB-tetningsplaten eller MASTER-tetningsplaten til en...
Kontakt oss
Vi svarer gjerne på spørsmålene dine