inglés
mineral, totalmente recubierto por ambas caras
número de artículo 070481
El sellado de juntas de construcción de hormigón plantea grandes exigencias a la tecnología de sellado.
Completamente recubierta con un revestimiento mineral especial, la lámina de sellado MB Overlap en forma de tira garantiza que las juntas de construcción de hormigón queden selladas de forma segura y permanente contra el agua de prensado y no prensado.
Ya no es necesario retirar la lámina protectora, lo que lleva mucho tiempo.
Añadir a la lista de avisos
La información más importante de un vistazo
start Animación
St 37, galvanized
special coating: mineral
duro, áspero
2,4 m
160 mm
Aproximadamente 0,6 mm
Aproximadamente 0,2 mm
ca. 1,0 mm
Certificado de prueba de la autoridad general de la construcción (AbP)
MPA Braunschweig
Informe de ensayo JGS
MPA Braunschweig
(1200/549/17) - Pan
Ja
Utilizar clase A para clase de carga 1 y 2 de acuerdo con la directriz WU
Caja de madera (255 x 25 x 31 cm)
50 unidades de listones
55 piezas abrazaderas a tope
para Alemania
hasta máx. 1,0 bar (columna de agua de 10 m, factor de seguridad de 2,5 veces)
The product is delivered in a wooden crate.
The Joint sheet metal MB Overlap elements and the fixing clips are in the crate.
Joint sheet metal MB Overlap elements are supplied ready to install.
A protective foil does not need to be removed.
Place the elements in the centre of the rising wall on top of the upper reinforcement layer.
Push the mounting brackets, 3 pcs/element, over the sheet metal and fix them to the upper reinforcement layer with binding wire.
The embedment depth in the concrete must be at least 3 cm and must not be more than half the height of the sheet metal (8 cm).
The joint of the Joint sheet metal MB Overlap can be made without glue, only by overlapping the two ends.
The length of the overlap must be at least 20 cm.
There must be no contamination on the surfaces that could interfere with bonding.
The joint must be secured with one of the fixing clips provided.
Attention: The Joint sheet metal MB Overlap must not be plugged into the fresh concrete subsequently.
Corners can be formed by sharp-edged bending in-situ on the
building site.
After some alignment the edge can be fixed on the reinforcement.
To facilitate the fixing of the Joint sheet metal MB Overlap on the reinforcement start installation in a corner.
The placement of concrete in the area of the Joint sheet metal MB Overlap and corresponding preparations must be carried out in accordance with the established technical standards.
Status: 23.03.2022
Accesorios
accesorios adecuados
Para asegurar las juntas de solapamiento de waterstops metálicos revestidos ...
Estribo de fijación para waterstops metálicos hasta una altura de 160 mm ...
Contacto
Estaremos encantados de responder a sus preguntas