Completamente rivestito su entrambi i lati
numero di articolo 070464
VB lamiere di giunzione in rotoli
L'impermeabilizzazione dei giunti delle costruzioni in calcestruzzo pone requisiti elevati alla tecnologia di sigillatura.
I fogli di tenuta rivestiti su uno o entrambi i lati, il rotolo di fogli di tenuta 120 VB1 o VB2, assicurano che i giunti di costruzione in calcestruzzo siano sigillati in modo sicuro e permanente contro l'acqua di pressione e non. Aggiungi all'elenco degli avvisi
Le informazioni più importanti in un colpo d'occhio
St 37, zincato
Rivestimento speciale: plastica polimerica rinforzata con tessuto
20 m
120 mm
circa 0,15 mmm
Circa 0,9 mm
Certificato di collaudo dell'autorità edilizia generale (AbP)
MFPA Lipsia
ja
Utilizzare la classe A per le classi di carico 1 e 2 secondo le linee guida WU
.No
Ja
Cartone (40 x 40 x 20 cm)
1 pz rotolo
2 pz morsetti di fissaggio
30 staffe di fissaggio
48 scatole per pallet
Remove the bottom half of the parted protective foil from the special coating.
Place the VB joint sheet metal in the centre of the rising wall on top of the upper reinforcement layer.
Push the mounting brackets with a maximum distance of 70 cm over the sheet metal and fix them to the upper reinforcement layer with binding wire.
The embedment depth in the concrete must be at least 3 cm and must not be more than half the height of the sheet metal.
PLEASE NOTE!! The coating of the joint sheet metal VB1 must face the waterlogged side!
The VB joint sheet metal must overlap by at least 6 cm in the area of the joint, in the straight sections and also in the corner area.
To do so, the upper protective foil must be turned back in the area subsequently to be joined.
Overlap the VB joint sheet metal by at least 6 cm and press the two ends firmly together.
The joint must be glued over its full height and entire surface to prevent subsequent water permeation.
There must be no contamination on the adhesive surfaces that could interfere with bonding.
Secure the joint with one of the fixing clips provided and fold the protective foil back onto the special coating.
Prepared joints in the straight sections as well as the corner area.
Once the foundation slab has been concreted, and before the wall formwork is closed or the double wall elements have been set up, the remaining protective foil must be removed.
The concreting of the wall base and corresponding preparations must be carried out in accordance with the established technical standards.
Status: 23.03.2022
Contattateci
Siamo lieti di rispondere alle vostre domande