med løkringteknologi - delt versjon
artikkelnummer 120222T
Den viktigste informasjonen på et øyeblikk
Tetningselement: Miljøvennlig EPDM-gummi
.
Tetningsbredde: 40 mm
Trykkplater, skruer, muttere: V2A
Trykkplater: sølvfarget
M8
13 mm
10 Nm (dimensjonsstabile medierør)
250 mm
Uten innvendig plugg: 158 - 160 mm
.
1. ring: 168 - 170 mm
.
2. Ring: 178 - 180 mm
3. ring: 198 - 200 mm
3. ring: 198 - 200 mm
3. ring: 198 - 200 mm
4. ring: 208 - 210 mm
Adjust the sealing insert of the MASTER-Ring Multi split version to the diameter of the media line. To do this, push the required rings backwards through the seal.
Remove the locking clip of the MASTER-Ring Multi split version
Open the gasket on the side of the puzzle pieces.
Place the MASTER-Ring Multi split version around the installed pipe.
Close the gasket and reinstall the locking clip and close it as well.
Push the seal into the annular gap.
Tighten the screws crosswise through one turn.
Tighten the screws to the specified max. torque. (Ø 100/150/200 = 5Nm; Ø250 = 10Nm).
Check the torque after 1-2 hours and retighten the screws if necessary.
Kontakt oss
Vi svarer gjerne på spørsmålene dine