med lökringsteknik - delad version
artikelnummer 120222T
Den viktigaste informationen i en överblick
Tätningselement: Miljövänligt EPDM-gummi
.
Tätningsbredd: 40 mm
Tryckplattor, skruvar, muttrar: V2A
Tryckplåtar: silverfärgade
M8
13 mm
.10 Nm (dimensionsstabila medierör)
250 mm
.Utan innerplugg: 158 - 160 mm
.
1:a ringen: 168 - 170 mm
.
2. Ring: 178 - 180 mm
3. ring: 198 - 200 mm
4. ring: 208 - 210 mm
4:e ringen: 208 - 210 mm
Adjust the sealing insert of the MASTER-Ring Multi split version to the diameter of the media line. To do this, push the required rings backwards through the seal.
Remove the locking clip of the MASTER-Ring Multi split version
Open the gasket on the side of the puzzle pieces.
Place the MASTER-Ring Multi split version around the installed pipe.
Close the gasket and reinstall the locking clip and close it as well.
Push the seal into the annular gap.
Tighten the screws crosswise through one turn.
Tighten the screws to the specified max. torque. (Ø 100/150/200 = 5Nm; Ø250 = 10Nm).
Check the torque after 1-2 hours and retighten the screws if necessary.
Kontakta oss
Vi svarar gärna på dina frågor