made of high-quality TPE; colour: red
article number 010045
For sealing construction joints and penetrations in concrete structures.
With a proven ability to withstand a pressure of 8 bar, FLOWSTOP satisfies the conditions of the German WU directive on water-impermeable concrete structures for a continuous pressure of 2 bar, as well as international standards that require high pressure resistance.
- General Building Supervisory Test Certificate
- Suitable for zones with frequently varying water levels
- Good chemical resistance
- Dimensionally stable
- Maximum pressure of 8 bar with size 20 x 5 mm
- Long-term testing for more than 250 days
- Easy installation with the POWER swelling tape adhesive
- No foundation curb required
The most important information at a glance
TPE
smooth
40 - 50 Shore A DIN 53505-A
up to 300% DIN 53571
up to 600%, in neutral water (ph7)
up to 100 %, in salt water
Test report (abP)
MFPA Leipzig
Nr.: P-SAC 02 / 5.1 / 13-515
Eropean Technical Assessment
ETA-18/0304
of 18 June 2018
Test report acid resistance
MPA Braunschweig
(1200/442/15d)-Pan of 28.10.2015
yes
Utility class A for the wear classes 1 and
2 in accordance with the WU guideline
e.g.
- Diluted acids and alkalis
- Salt water
- Methane gas
- Radon
- Liquid manure and slurry
- Fermentation mash and biogas
- Concrete alkalinity
- Mineral oils
- Fuels (Petrol, Diesel, Kerosine)
Only the system-compatible POWER swelling tape adhesive is suitable for installation.
FLOWSTOP High-pressure swelling tape must not be installed using swellingtape grid!
The substrate must be clean, dry, and free ofloose particles. Apply the POWER swelling tape adhesive in a uniform bead (width 8-10 mm) out of the cartrige onto the surface.
Once the POWER swelling tape adhesive has been applied in the centre of the joint, the FLOWSTOP High-pressure swelling tape is placed on the adhesive and gently pressed on, moving it slightly back and forth, crosswise to the longitudinal axis. When the tape is fixed, the adhesive should slightly ooze out on both sides. This guarantees a complete fixation.
A concrete cover of 8cm must be ensured. FLOWSTOP High-pressure swelling tape must always be installed inside a two-sided connection reinforcement.
Both, straight and angle joints need to be butt jointed. The joint areas must be form-fit in order to avoid any discontinuity in the system.
Angle joint
Straight butt joint
Status: 23.03.2022
Accessories
suitable accessories
Cartridge 310 ml high-pressure adhesive 1 cartridge = approx. 8 m single-component solvent-free sealant for bonding of MA...
Contact us
We are happy to answer your questions