English
200 mm - with "onion ring" technology - split version
article number 120193T
The most important information at a glance
rubber: EPDM
sealing width: 40 mm
pressure plates, screws, nuts: V2 A
pressure plates: silvery
M6
10 mm
5 Nm at form stable media pipes
200 mm
Without plug: 108 - 110 mm
1. Ring: 123 - 125 mm
2. Ring: 138 - 140 mm
3. Ring: 158 - 160 mm
Adjust the sealing insert of the MASTER-Ring Multi split version to the diameter of the media line. To do this, push the required rings backwards through the seal.
Remove the locking clip of the MASTER-Ring Multi split version
Open the gasket on the side of the puzzle pieces.
Place the MASTER-Ring Multi split version around the installed pipe.
Close the gasket and reinstall the locking clip and close it as well.
Push the seal into the annular gap.
Tighten the screws crosswise through one turn.
Tighten the screws to the specified max. torque. (Ø 100/150/200 = 5Nm; Ø250 = 10Nm).
Check the torque after 1-2 hours and retighten the screws if necessary.
Contact us
We are happy to answer your questions